Power; Ethernet Ports - AMX NXA-WAP1000 Reference Manual

NXA-WAP1000 (FG2255-51/53) Specifications (Cont.)
Front LED Indicators (Cont.)
5G:
Rear Components:
OPT:
Hard Reset:
10/100 Ports (2):
10/100/1000 PoE Port:
External Power Port:
Operating Temperature:
Operating Humidity:
Certifications:
Included Accessories:
Other AMX Equipment:

Power

The AP does not have a power switch. It utilizes Power Over Ethernet (PoE), which draws power from its
Ethernet connection. An optional power supply (FG2255-61) may also be used in circumstances where PoE is
not available, via the External Power port (FIG. 2).

Ethernet Ports

The access point has two 10BASE-T/100BASE-TX RJ-45 ports and one 10/100/1000 RJ-45 port that can be
attached directly to 10BASE-T/100BASE-TX LAN segments. These segments must conform to the IEEE
802.3-2005 specifications.
These ports supports automatic MDI/MDI-X operation, so you can use straight-through cables for all network
connections to PCs, switches, or hubs.
NXA-WAP1000 Smart Wireless Access Point
• Off: The WLAN service is down.
• Amber: The WLAN service (or mesh network) is up and at least one wireless
client is associated, but RSSI is low. If mesh networking is enabled, at least
one downlink MAP is connected.
• Green: The wireless WLAN service (or mesh network) is up and at least one
wireless client is associated. If mesh networking is enabled, at least one
downlink MAP is connected.
• Fast flashing green (two flashes every second): The WLAN service (or mesh
network) is up, but no wireless clients or downlink MAPs are currently
associated.
• Slow flashing green (one flash every two seconds): The WLAN service is up,
no wireless clients are currently associated, mesh networking is enabled and
at least one downlink MAP is connected.
• Not active at this time.
• Pressing, and then quickly releasing this internal button reboots the
NXA-WAP1000.
• Pressing and holding it for six seconds resets the NXA-WAP1000 to factory
default settings.
• Two RJ-45 ports for 10/100Mbps connections.
• One RJ-45 port for a 10/100/1000 PoE (Power over Ethernet, 802.3af)
connection.
• Connects a power supply (12 VDC/1.25A) to this port. Power may also be
supplied via the 10/100/1000 PoE (802.3af) port.
• Operating: 0 to 40 °C (32 to 104 °F)
• Storage: -20 to 70 °C (32 to 158 °F)
15% to 95% (non-condensing)
• FCC
• IC
• CE
• C-Tick
• RoHS
• Category 5 (CAT5e) network cable
• NXA-WAP1000 Installation Guide (93-2255-51)
• Mounting Template (93-2255-55)
• #4 sheet metal mounting screws (2) with molly bolts (2) for wall installation
• NXA-WAP1000 Power Supply (FG2255-61)
• NXA-ENET8POE PoE Switch (FG2178-62)
• NXA-WAPZD1000 Wireless LAN Zone Director (FG2255-52)
NXA-WAPZD1000 Smart Wireless Access Point
3