Radio 2.4G - AMX NXA-WAP1000 Reference Manual

Radio 2.4G

The Radio 2.4G page displays information on connections to wireless LANs using the 2.4G radio in the
NXA-WAP1000.
FIG. 10 Status - Radio 2.4G - Common page
Radio 2.4G - Common
Enable/Disable Auto-update:
Tabs:
Channel:
Channel Width:
Country Code:
AeroScout RFID Detection:
AeroScout Engine
Communication Daemon:
NXA-WAP1000 Smart Wireless Access Point
Click this button to allow or disable the ability for the NXA-WAP1000 to
automatically update its settings and firmware.
These tabs access pages for common status settings within a network and
within individual WLANs.
Shows the wireless channel that the AP is currently using. If you set the
wireless channel to SmartSelect, this field will show the value Channel #
[SmartSelect].
Displays whether the channel width is set to 20MHz or 40MHz.
Shows the country code that the AP has been set to use.
CAUTION: Verify that the AP is using the correct country code to make
sure it uses only the allowed radio channels in your region. Selecting the
incorrect country code may result in violation of regulatory laws.
Shows Enabled if you enabled AeroScout RFID tag detection. The default
setting is Disabled.
Shows Up if the communication agent on the AP is able to relay location data
from AeroScout Tags to the AeroScout Engine. If the communication agent is
unable to relay data or AeroScout tag detection is disabled, this field will show
Down.
Browser-Based Configuration Pages
23