Configuration; Device; Changing The Administrative Login Settings - AMX NXA-WAP1000 Reference Manual

Configuration

The Configuration section contains pages for initial configuration of the NXA-WAP1000. For more
information on initial configuration, please refer to the Preconfiguring the NXA-WAP1000 section on page 8.
If the NXA-WAP1000 is already configured, or if it is being managed by an
NXA-WAPZD1000 ZoneDirector, this section will not be visible in the Browser-Based
Configuration Pages. This section will be accessible again only if the device is reset
to its factory defaults.

Device

FIG. 14
Configuration - Device page
Configuration - Device
Device Name:
Device Locations:
GPS Coordinates:
Service Provider Login:
Username:
Current Password:
New Password:
Confirm New Password:
Update Settings:

Changing the Administrative Login Settings

The default user name is admin and the default password is 1988. To prevent unauthorized users from logging
in to the Browser-Based Configuration Pages using these default administrator login settings, changing the
default Web interface password immediately after your first login is highly recommended.
To change the default administrator login settings:
1.
Go to Configuration > Device. The Device page appears.
2.
Under Service Provider Login, change the default administrator login settings.
NXA-WAP1000 Smart Wireless Access Point
Type a new name for the device or leave as is to accept the default device
name (amxAP). The device name identifies the AP among other devices on the
network.
Type the address or location where the device is deployed.
Type the latitudinal and longitudinal coordinates of the device location.
Type the name that you want to use for logging into the Browser-Based
Configuration Pages. The default user name is admin.
Type the current administrative password. The default administrative password
is 1988.
Type the new password that you want to use. The password must consist of six
to 32 alphanumeric characters only.
Retype the new password to confirm.
Click this button to save and apply your changes.
Browser-Based Configuration Pages
27