Repair; Rear Wheels Removal & Installation; Front Wheel Bearing Repair - Sabre 1338 Gear Technical Manual

MISCELLANEOUS

REPAIR

FRONT WHEELS REMOVAL &
INSTALLATION
1. Safely lift and support tractor.
2. Remove plastic cap.
3. Remove snap ring (A) and wheel.
4. Clean axle, washers, and bearings of old grease.
5. Inspect bearings for excessive wear. Replace if
necessary.
NOTE: Front wheels are installed with valves to the
inside.
6. Grease spindles with specified grease.
Cap
7. Install two washers on axle.
8. Install wheel on axle.
9. Place large washer on axle and install snap ring.
10. Install plastic cap.
9 - 4
www.servicemanualall.com
A
Two (2) Washer
Washer
Snap Ring
REAR WHEELS REMOVAL &
INSTALLATION
1. Safely lift and support tractor.
F
2. Remove plastic cap (C), E-ring (D) (gear) or snap
ring (F) (hydro), and outer washer (E).
3. Remove wheel.
NOTE: Rear wheels are installed with valves to the
outside.
4. Apply grease to axle shaft and key.
5. Install wheel on axle.
6. Install outer washer (E), E-ring (D) or snap ring (F),
and plastic cap (C).

FRONT WHEEL BEARING REPAIR

1. Remove bearings (A) using slide hammer puller.
Bearings
2. Install new bearings using suitable driver on outside
race of bearing.
REPAIR
B
A
C
D
E
M55832
M52004
3/5/97