Transaxle Assembly-K55 - Sabre 1338 Gear Technical Manual

HYDROSTATIC POWER TRAIN
block are damaged, they both must be replaced.
If any component of motor cylinder block is
damaged, a complete new motor cylinder block
must be ordered. If upper or lower case halves
show wear or damage, they need not be ordered
as a set unless wear or damage is severe
enough.
TRANSAXLE ASSEMBLY—K55
IMPORTANT: Coat all components lightly with
fresh oil before assembly, especially any mating
surfaces between components.
Assemble and Install Pump Shaft Assembly—
IMPORTANT: Carefully install pump shaft
assembly so case bore is not damaged.
1. Assemble pump (input) shaft and carefully install it
into upper case with snap ring (C).
2. Wrap tape around shaft splines (A) to protect seal.
3. Apply grease to lip surfaces of seal (B) before
installing it flush with case lip.
Install Pump, Swashplate, and Shifter Shaft
Assemblies—
IMPORTANT: READ THESE NEXT FOUR
PROCEDURES COMPLETELY BEFORE
PROCEEDING.
6 - 50
www.servicemanualall.com
A
C
B
C
B
D
I
H
K
1. Install swashplate thrust plates (A).
2. Install new o-ring (E) on shifter shaft.
3. Install swashplate (F), shift blocks (D) (apply grease
to help hold blocks in place), ball joint (C), and
shifter shaft (B) together.
REPAIR
A
C
E
F
J
G
L
2/12/97