Shift Linkage Removal & Installation - Sabre 1338 Gear Technical Manual

GEAR POWER TRAIN
SHIFT LINKAGE REMOVAL &
INSTALLATION
1. Remove battery.
2. Block rear of tractor off ground. Remove left drive
wheel.
3. Remove shift knob (G).
4. Remove lock nuts (M and O) to remove shift link
(N).
5. Remove lock nuts (A and I) and cap screws (B and
F).
A
P
15 N•m
(11 lb-ft.)
A–Lock Nut
B–Cap Screw
C–Shift Lever Cap Screw
D–Lock Washer
E–Washer
F–Cap Screw
5 - 22
www.servicemanualall.com
B
O
N
15 N•m
(11 lb-ft.)
G–Shifter Knob
H–Shift Rod
I–Lock Nut
J–Right-Hand Bracket
K–Special Square-Hole Washer
L–Shift Lever
6. Adjust mounting brackets (J and P) so shift rod (H)
can be removed from the left side of the frame. You
will have to "snake" the shift rod from the tractor.
7. Remove cap screw (C) to remove shift lever (L) and
washers (D, E, and K).
8. Replace necessary components.
9. Install shift linkage in reverse order of removal.
10. Tighten shift lever cap screw and lock nuts to
specifications shown.
C 16 N•m
(12 lb-ft.)
D
E
M
L
K
G
F
H
I
15 N•m
(11 lb-ft.)
J
M–Lock Nut
N–Shift Link
O–Lock Nut
P–Left-Hand Bracket
REPAIR
2/12/97