Table of Contents
Advertisement
9.9
To switch ECO mode on / off
You can switch on ECO mode to reduce the level of power
emissions and save battery power.
D
Menu
1. Press
, scroll
to
D
Set Base
2. Scroll
to
and press
D
ECO Mode
3. Scroll
to
and press
U
D
Off
4. Scroll
or
to
or
O
5. Press
to return to standby mode.
NOTE
When the ECO mode is set to ON, the
with
icon. The base transmission power will be reduced.
Registration
Settings
Select
and press
.
Select
.
Select
.
On
Select
then press
to confirm.
icon is replaced
10. Registration
Up to 5 handsets can be registered to one base station.
Additional handsets must be registered to the base before
you can use them.
• The instructions described below apply specifically to the
CD1 handset. If you wish to register another
manufacturer's handset, the instructions may vary. In this
case, please refer to the instruction manual of the
additional handset.
• The System PIN is required to register or unregister
handsets. The default PIN is 0000.
10.1
To register a handset
On the base:
B
1. Press and hold
for 3 seconds until the base LED
starts flashing. The base will remain in registration mode
for 90 seconds.
On the handset:
1. If the handset is new, the display shows
D
Menu
Press
, scroll
to
Or
If the handset has already been registered to another
base, the standby display is shown. Press
D
Registration
to
and press
Please register
Registration
Select
and press
Menu
, scroll
Select
.
.
.
37
Hide quick links:
Advertisement
Table of Contents
