Pin Assignment; 12-Pin Multi-Connector (Dc-In/Video Out, Ext.hd/Vd In); 6-Pin Multi-Connector (Trigger) - JAI CV-A2 Operation Manual

5. Pin Assignment

5.1. 12-pin Multi-connector (DC-IN/VIDEO OUT, EXT.HD/VD IN)

Type: HR10A-10R-12PB-01 (Hirose) male
Seen from rear
9
1
2 8
10
11
3 12 7
4
6
5
Fig. 2. 12-pin connector.

5.2. 6-pin Multi-connector (TRIGGER)

Type: HR10A-7R-6PB (Hirose) male
Seen from rear.
1 6
2 5
3 4
Fig. 3. 6-pin connector.
Notes.
*) Alternative signals can be placed on these pins by switch or jumper settings or
RS-232C commands.
Configurations shown in Bold + italic is factory setting.
*2) EEN will be low all the time in normal continous mode (TR=0), if the selected
exposure time is longer than the frame readout time.
CV-A2
Pin configuration is compatible with EIAJ standard
Pin no. Signal
1 GND
2 +12 V DC input
3 GND
4 Video/Iris video
5 GND
6 HD input/HD output
7 VD input/VD output
8 GND
9 Pixel clock output
10 WEN output
11 Trigger input
12 GND
Plugs for cable: HR10A-10P-12S
Pin no. Signal
1 TXD out
2 RXD in
3
4
5 Trigger input
6 EEN/WEN output
Plugs for cable: HR10A-7P-6S
- 4 -
Remarks
(IS=1 for iris video). 0.7 Vpp >1kΩ termination
*) SW502.3 on for 75Ω. SW501.1 on for HD out.
*) SW502.4 on for 75Ω. SW501.2 on for VD out.
PC=1 for pclk out. R615 short
Remarks
GND
GND
Parallel with pin 11 on 12 pin con
*) *2). WEN output if EW=1