Husqvarna Viking Scandinavia 400 User Manual page 27

Removing the Embroidery
Foot U
!
Turn off the main switch.
1. Raise the presser foot lever.
2. Unscrew the presser foot.
3. Remove the presser foot U
from behind out of the presser
bar by pushing the presser foot
downward.
4. Insert the presser foot ankle, screw
and tighten. Snap on the desired
presser foot (see page 14).
Attach the Embroidery
Foot U
!
Turn off the main switch.
Raise the presser foot lever and
remove the presser foot.
Use the screw driver to loosen the
screw on the presser foot ankle.
Remove the ankle.
Place the Embroidery Foot U, from
behind onto the presser foot bar. The
arm of the presser foot should rest on
top of the needle clamp screw. Use the
hand wheel to lower the needle slightly
until the foot slides in place.
Position the foot so that the hole
on the foot matches the hole on the
presser foot bar.
Insert the screw and tighten the screw
with the screw driver.
Embroidery
3.
2.
27