Husqvarna Viking Scandinavia 400 User Manual page 33

8. The machine stops automatically
when it is time to change thread
color. The Infodisplay indicates
which thread color change you
have reached by a ashing number
next to the thread spool
ashing number indicates the rst
stitch of the "new" thread color.
The number stops ashing when
you begin to sew.
9. Once thread is changed, start
sewing again. The machine stops
for cutting the thread tail and at the
next thread color change etc., until
the embroidery is completed.
During the stitching, as the embroidery
hoop moves to different places within
the embroidery, jump stitches are
sewn. Trim these stitches as you sew,
i.e. when the machine stops for thread
color change.
In most cases the embroidery is sewn
over the jump stitches, but in some
cases a part of the thread can be
visible and dif cult to trim later.
If the upper thread breaks while
sewing, the machine stops and gives
a signal. The symbol
on the display. Rethread the machine.
Go back a few stitches using the
button and restart. The symbol goes
out.
The machine also stops when the
thread spool runs out. When this
occurs, simply rethread the top thread.
Go back a few stitches past the point
where the spool thread ran out,
using the
embroidery will be completed.
If the bobbin thread runs out, touch
. A
CLR to move the hoop and give
enough space around the bobbin
area to change the bobbin. Wind and
replace the bobbin. Touch CLR again
and the hoop moves back to where
you stopped embroidering. Go back
a few stitches using the
Restart and the embroidery will be
completed.
At any time during the embroidery
stitching, check how much bobbin
thread is left, touch CLR. The
embroidery arm goes to park position.
Touch CLRto move the embroidery
arm back to stitch position and pull
any exess upper thread back.
Hint: When bobbin winding with the
embroidery unit connected, thread
the machine as described on page
11 - "Bobbin winding direct". Then
touch
will stop automatically when bobbin
winding is nished.
After nishing the embroidery
sewing:
1. Remove the embroidery hoop by
is ashing
2. Touch CLR and the embroidery
button. Restart and the
(RUN/STOP). The bobbin
pressing the button to the right on
the hoop. Pull the hoop toward
you.
arm returns to ready position. In
this position you may remove the
embroidery unit from the machine
(by pushing the button on the
center left underside), after turning
the machine off.
Embroidery
button.
33