Config Ipif System; Logout; Ping - D-Link DGS-1210-10P Reference Manual

6 Command Line Interface
DGS-1210-52>

config ipif system

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the IPv6 interface System:
DGS-1210-52> c onfig ipif S ys tem ipv6 ipv6addres s 3ffe:501:ffff:100::1/64
S uc c es s .
DGS-1210-52>

logout

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To terminate the current user's console session:
DGS-1210-52> logout

ping

Purpose
Syntax
To configure the System IPv6 interface.
config ipif system { ipv6 ipv6address <ipv6networkaddr> |
dhcpv6_client [enable | disable] }
The c onfig ipif s ys tem command configures the System IPv6
interface on the Switch.
ipv6 ipv6address <ipv6networkaddr> − Use this parameter to
statically assign an IPv6address to this interface. This address
should define a host address and a network prefix length.
Multiple IPv6 addresses can be configured for a single IP
interface. Ex: 3ffe:501:ffff:100::1/64. The /64 represents the prefix
length of the IPv6 addresses.
dhcpv6_client [enable | disable] − Specify the DHCPv6 client to
be disabled or enabled.
None.
To log out a user from the Switch's console.
logout
The logout command terminates the current user's session on
the Switch's console.
None.
None.
NOTE: Save your configuration changes before
logging out.
To test the connectivity between network devices.
<ipaddr>
9 3
9 3
D-Link Web Smart Switch User Manual