Security > Smart Binding > Smart Binding Settings - D-Link DGS-1210-10P Reference Manual

5 Configuration
Security > Smart Binding > Smart Binding Settings
The primary purpose of Smart Binding is to restrict client access to a switch by enabling administrators to
configure pairs of client MAC and IP addresses that are allowed to access networks through a switch.
The Smart Binding function is port-based, meaning that a user can enable or disable the function on any
individual port. Once Smart Binding is enabled on a switch port, the switch will restrict or allow client access
by checking the pair of IP-MAC addresses with the pre-configured database, also known as the "IMPB white
list".
Users can enable or disable the Inspection packets and DHCP Snooping on the Switch.
The Smart Binding Settings page contains the following fields:
From Port/ To Port: Select a range of ports to set for IP-MAC-port binding.
State: Use the drop-down menu to enable or disable these ports for Smart Binding.
Enabled –Enable Smart Binding with related configurations to the ports
Disabled –Disable Smart Binding.
Packet Inspection: Specifies ARP Inspection or IP+ARP Inspection for the IP packets. If ARP inspection is
selected, the Switch will inspect incoming ARP packets and compare them with the Switch's Smart Binding
white list entries. If the IP-MAC pair of an ARP packet is not found in the white list, the Switch will block the
MAC address. A major benefit of Loose state is that it uses less CPU resources. However, it cannot block
malicious users who send only unicast IP packets. An example of this is that a malicious user can perform
DoS attacks by statically configuring the ARP table on their PC. In this case, the Switch cannot block such
attacks because the PC will not send out ARP packets. If ARP+ IP Inspection mode is selected, the Switch
Figure 5.78 – Security > SSL Settings
NOTE: When SSL is enabled, it will take longer
time to open a web page due to encryption. After
saving configuration, please wait around 10
seconds for the system summery page.
Figure 5.79 – Security > Smart Binding > Smart Binding Settings
62
D-Link Web Smart Switch User Manual