D-Link DGS-1210-10P Reference Manual page 82

5 Configuration
3) After the Profile ID has been created, click Continue to go back to the main Access Profile List page,
clicking the Edit / New Rules button to enter the Access Rule List page.
Profile ID: Indicates the corresponding access profile Identification number.
Access ID: Indicates the access rule Identification number.
Profile Type: Displays the profile type.
Summary: Displays the access rule summary.
Action: Displays the access rule action.
To add a new rule, click Add:
Profile Information displays the information to which the rule is being added to, including Profile ID and
Ether Type.
In Rule Detail, you can specify the details of an access rule. Below are all the possible parameters that can
be set.
Access ID: Specify the Access ID (1-65535).
Type: Display the type of rule. MAC, IPv4 or IPv6.
IPv6 Class: Specify the class of IPv6. The range is 0 to 255.
VLAN ID: Specify the VLAN ID.
Destination IPv6 Address: Specify the destination IPv6 address.
Source IPv6 Address: Specify the source IPv6 address.
IP Protocol: Specify the IP protocol of access rule.
Type: Specify the type. The possible value is from 0 to 255.
Code: Specify the code of access rule. The field range is from 0 to 255.
Ports: Specify the switch ports that you want to implement the access rule to.
Action: Specify the ACL forwarding action matching the rule criteria. Permit forwards packets if all
other ACL criteria are met. Deny drops packets if all other ACL criteria is met.
Figure 5.97 – Access Rule List
Figure 5.98 – Add Access Rule
7 7
7 7
D-Link Web Smart Switch User Manual