Selecting Measurement Function; Configuring Scan Parameters - Keithley 2000-Scan Instruction Manual

Remote interface
Use the :ROUTe:OPEN:ALL command to open all of the channels. The command is as
follows:
PRINT #1, "output 16; :route:open:all"
Use the :ROUTe:MULTiple:OPEN command to open specified channels. For example, if you
wish to open channels 1, 3 and 5, use the following command:
PRINT #1, "output 16; :route:multiple:open (@1,3,5)"
Note that opening channel 11 selects the 2-pole operating mode.

Selecting measurement function

This section describes how to select a specific measurement function for an internal channel.
1. Use the
2. Select the desired measurement function with the keys on the front panel. The various
measurement functions available are:
DCV: DC volts
ACV: AC volts
Ω2W: 2-wire ohms
Ω4W: 4-wire ohms (channels 1-5)
FREQ: frequency
Configuring scan parameters
This section details how to select internal scanning and how to configure the scan parameters.
Front Panel
Use the SHIFT-CONFIG keys to select the scan type and configure the scan parameters.
1. Press SHIFT then CONFIG. The instrument will display the following prompt for
internal scanning:
TYPE: INT
Use the ▲ or ▼ key if EXT is displayed. Then press ENTER.
2. The following message will be displayed:
MIN CHAN: 1
Use the ▲ and ▼ keys to select the channel at which the scanning will begin, then press
ENTER.
3. The unit will then display the following message:
MAX CHAN: 10
Use the
then press ENTER.
and keys to select the desired channel.
, ▲, and ▼ keys to select the channel at which the scanning will stop,
,
PERIOD: period
TEMP: simulated temperature
CONT: continuity
: diode test
Operation 3-5