Scanner Card Installation; Figure 2-10 Card Installation - Keithley 2000-Scan Instruction Manual

2-16 Card Connections and Installation

Scanner Card Installation

Perform the following steps and refer to
multimeter:
WARNING
Figure 2-10
Card installation
1.
2.
3.
4.
Turn off power to all instrumentation (including the multimeter) and
disconnect all line cords. Make sure all power is removed and any stored
energy in external circuitry is discharged.
Unlock card
Ejector Arms (2)
Lock card
Note: Card installation in a Model 2001/2002
is shown. For installation in Model 2000,
turn card over.
Remove the cover plate from the OPTION SLOT on the rear panel of the multimeter. To
Do so, pry out the two fasteners, then remove the Cover plate.
Slide the card edges into the guide rails inside the multimeter (solder side up for
Model 2001/2002, component side up for Model 2000).
With the ejector arms in the unlocked position, carefully push the card all the way
forward until the arms engage the ejector clips. Push both arms inward to lock the card
into the multimeter.
After installation, connect the output leads to the multimeter as discussed below.
Figure 2-10 to install the card assembly in the