Card Connectors; Figure 2-2 Card Connectors - Keithley 2000-Scan Instruction Manual

Card connectors

Figure 2-2
•
•
•
In order to gain access to the connections, first open the plastic shield by pressing in on the
locking tab. Swing the shield away from the circuit board.
Figure 2-2
Card connectors
shows the input/output connectors for the card. Card connections include:
CH 1-10 (channels 1-10): HI and LO input terminals are provided for each of the 10
channels on the card.
OUT A: HI and LO output connections for all ten channels in the 2-pole mode or
channels 1-5 in the 4-pole mode.
OUT B: HI and LO output connections for channels 6-10 in the 4-pole mode.
Channels 1-5, OUT A
H L H L
CH 1 CH 2
Locking Tab
Card Connections and Installation
Channels 6-10, OUT B
H L H L H L H L H L
H L H L
CH 3 CH 4 CH 5 CH 6
OUT A CH 7 CH 8
Plastic Shield
H L H L H L
CH 9 CH 10
OUT B
2-5