Table of Contents
Advertisement
28
Siemens Building Technologies
Fire Safety & Security Products
6.
Clamp around the cable. Take care not to damage the cable.
7.
Complete the connector assembly by sliding all parts into the connector body
and hand tightening the locking nut. Sufficient force must be applied to the
locking nut to compress the rubber washer, thus sealing the assembly. When
sufficiently tight hold the assembly to a light source; if correctly sealed, light
will not be seen though it. If light can be seen, hand tighten with more force.
8.
Finally, loop the cable as shown.
9.
Lock the cable in position with the cable tie provided. This 'loop and tie' will
divert water that runs down the cable away from the connector assembly.
08.2006
Hide quick links:
Advertisement
Table of Contents
