Configuration Of The Dome Unit; On-Screen Display Menus - Siemens Solaris CCDS1415-ST Configuration Manual

11

Configuration of the Dome unit

11.1

On-screen display menus

Siemens Building Technologies
Fire Safety & Security Products
Most of the Solaris™ Dome's advanced functions are configured using a menu
system that is presented by the camera's on-screen display (OSD). This section of
the manual covers the use of the OSD menu system, and explains the options it
provides.
When the Dome is new or after a factory reset has been performed, a default tour
is already stored comprising of sixteen preset positions (1 to 16). These preset
positions can be overwritten by storing new positions or by selecting 'Clear
Presets' from the Reset menu.
The menus system presented by the OSD is controlled by using keys on the
system telemetry controller. Since the Solaris™ Dome can be controlled by a wide
range of telemetry controllers, the position and labelling of the specific keys used
may vary from system to system. Refer to Section 12: Telemetry controller
operation and setup for specific information.
Menu flowcharts overview
The OSD's main menu contains 8 items, all of which lead to a sub-menu system of
commands when selected. Details of each of these sub-menus and the commands
they contain are presented as flowcharts on the following pages.
CAMERA This menu provides access to several of the camera's advanced functions.
See Section 11.1.2: The Camera menu for details.
PRESETS TOURS This menu is used to set up stationary preset positions, pre-programmed
PATTERNS tours of specific presets, and to record any of the four patterns - a series of
manual movements that can be recorded and then replayed as an alternative
to a tour. It is also used to assign actions to presets; such as recalling tours
and to assign presets to alarms. See Section 11.1.3: The Presets, Tours and
Patterns menu for details
PRIVACY ZONES This section of the menu system will allow you to set up Privacy Zones.
These are pre-defined sections of the cameras field of view that are blanked
to provide privacy for occupants of the areas covered. See Section 11.1.4:
The Privacy Zones menu for details
SOFT LIMITS AND Soft Limits will allow you to set up and remove software limits that restrict the
SECTORS vertical travel of the camera. Sectors will allow individual identification, by
name, of the 16 sectors available within the Solaris™ Dome's horizontal
movement.
43
08.2006