Introduction - REMEHA Avanta 24c Installation And Service Manual

Introduction

INTRODUCTION
fig. 01 Remeha Avanta Plus
112952.LT.GB.W7H.001
4
112952LTGBW7H001b
The Remeha Avanta Plus is a series of high-efficiency fully
condensing central heating boilers, for wall mounting, available
in the following types:
• R emeha Avanta Plus 24c, 28c, 35c and 39c - with integrat-
ed domestic hot water system (Combi-type)
• R emeha Avanta Plus 18s, 24s, 30s - without integrated
domestic hot water system (System-type)
These technical instructions contain useful and important infor-
mation for the correct installation, operation and maintenance
of the Remeha Avanta Plus combi and system boilers.

Read these instructions carefully before putting the boiler into
operation, familiarise yourself with their control functions and
operation, strictly observing the instructions given. Failure to
do so may invalidate warranty or prevent the boiler from
operating correctly.
The installation, commissioning, inspection and servicing of
the boiler must be carried out by a competent registered engi-
neer who holds valid ACS certification and in accordance with
current gas safety (installation and use) regulations, the build-
ing regulations and all other relevant codes of practice.
All electrical work must be carried out by a competent engi-
neer and to be installed in accordance with the current IEE
regulations.
It is the responsibility of the installer to ensure that all flue sys-
tems are installed in accordance with manufacturers instruc-
tions and all the requirements of EN 14471.

On commissioning the certificate in the Benchmark Checklist
within the Installation + Service manual must be completed
and left on site with a copy send on to Remeha for
registration purposes.
If you have any questions, require an engineer to call on site,
or if you need more information about specific subjects relating
to this boiler, or it's installation please do not hesitate to con-
tact our technical help line 0118 974 3070.

When contacting Remeha with a problem on the boiler, please
have available the boiler type, Serial No (located on the
bottom of the casing), and the symptoms or fault code (the
fault code is a series of flashing red digits in the display panel).
The data published in these technical instructions is based on
the latest information (at date of publication) and may be sub-
ject to revisions.
We reserve the right to continuous development in both design
and manufacture, therefore any changes to the materials or
technology employed may not be retrospective nor may we be
obliged to adjust earlier supplies accordingly.
Remeha Avanta Plus
127768-271011