Recording A Movie From Pictures Taken At A Set Interval (Interval Movie) - Pentax WG-10 Operating Manual

5
Use the four-way controller
(45) to select O (On) or
P (Off).
O(On)
P (Off)
The setting is saved.
6
Press the 3 button twice.
The camera returns to capture mode.
Recording a Movie from Pictures Taken at a Set
Interval (Interval Movie)
In this mode, you can record multiple still pictures taken automatically at
a set interval from a set time, as a movie file.
Interval You can set this to 1 minute, 5 minutes, 10 minutes, 30 minutes, or 1 hour.
Set the total time, from 10 minutes to 359 hours. The total time and the
Total Time settable units change depending on the interval set. The Interval can be set
in increments of 1 minute, 5 minutes, 10 minutes, 30 minutes, or 1 hour.
Set the start delay, from 0 minutes to 24 hours. The start delay can be
set in increments of 1 minute for a delay time up to 59 minutes, and
Start Delay increments of 1 hour for a delay time longer than one hour. If the start
time is set to 0 minutes, the first picture is taken as soon as the shutter
release button is pressed.
Setting from Drive Mode
1
Press the four-way controller (2) in C or
2
Use the four-way controller
(45) to select k (Interval
Shoot) and press the 4
button.
The current Interval Movie setting
appears for approximately one
minute. To take pictures with the
current settings, go to step 10.
Automatically corrects
for camera shake.
No correction for
camera shake.
Movie
Recorded Pixels
Movie SR
Interval Shoot
MENU
mode.
Drive Mode Drive Mode Drive Mode
Interval Shoot Interval Shoot Interval Shoot
Cancel Cancel Cancel
MENU MENU MENU
3
OK OK OK
OK OK OK
145