Saving The Settings (Memory) - Pentax WG-10 Operating Manual

Saving the Settings (Memory)

The Memory function is for saving the current camera settings when the
camera is turned off.
For some camera settings, the Memory function is always set to O (On) (the
settings are saved when the camera is turned off), while for others you can
choose on or off (to choose whether the settings are saved or not when the
camera is turned off). The items which can be set to On or Off in the Memory
function are shown in the table below. (Items not listed here are always
saved in the selected settings when the camera is turned off.)
If you select O (On), the settings will be saved in the status they were in
immediately before the camera was turned off. If you select P (Off), the settings
will be reset to the defaults when the camera is turned off. The table below also
shows whether the Memory default setting for each item is on or off.
Item
Face Detection
Flash Mode
Drive Mode
Focus Mode
Zoom Position
MF Position
White Balance
Sensitivity
EV Compensation
AE Metering
Digital Zoom
DISPLAY
File No.
Description
A Face Detection mode set by using the I
button.
The flash mode set with the four-way
controller (4)
The drive mode set with the four-way
controller (2)
The focus mode set with the four-way
controller (5)
The zoom position set with the w/x
button.
The manual focus position set with the four-
way controller (23)
The [White Balance] setting on the [A Rec.
Mode] menu
The [Sensitivity] setting on the [A Rec.
Mode] menu
The [EV Compensation] setting on the [A
Rec. Mode] menu
The [AE Metering] setting on the [A Rec.
Mode] menu
The [Digital Zoom] setting on the [A Rec.
Mode] menu
The display information display mode set
with the 4/W button
If a new SD Memory Card is inserted when
On has been selected, file numbers are
assigned sequentially.
Default
Page
setting
p.71
P
p.108
O
p.94 -
P
p.101
p.110
P
p.79
P
p.111
P
p.119
P
p.122
P
p.124
P
p.121
P
p.81
O
p.23
P
⎯
O
3
149