Pentax WG-10 Operating Manual page 272

Message
Data being recorded
Data being processed
Built-in memory full
No image to be
processed
This image/sound
cannot be processed
No card in the camera
The built-in memory is
not enough to copy
images/sounds
Cannot process
correctly
Not enough battery
power remaining to
activate Pixel Mapping
No more images can be
selected
The camera will turn off
to prevent damage from
overheating
9
270
Displayed when you try to switch to Q mode while an
image is still being recorded, or when the protect setting or
DPOF setting is being changed. It disappears after the
image is recorded or the setting is changed.
Displayed when the camera takes more than five seconds
to display an image due to image processing, or when the
SD Memory Card or the built-in memory is being formatted.
Displayed if the built-in memory is full when saving a file.
Displayed when there are no images or sound files.
Displayed for files that cannot be processed.
Displayed if no SD Memory Card is inserted when "Image/
Sound Copy" is selected from the Playback Mode Palette
and the OK button is pressed.
Displayed when there is insufficient built-in memory to
perform copying.
Displayed when Red-eye Compensation processing fails.
Displayed when the battery is too low during Pixel Mapping.
Change the battery (p.34) or use the AC adapter kit
K-AC117 (optional) (p.38).
Displayed when you select more than the maximum
number of images.
Appears when the temperature inside the camera exceeds
the highest limit.
Description