Pentax WG-10 Operating Manual page 100

3
Use the four-way controller
(45) to select i or h and
press the 4 button.
The self-timer lamp begins to blink
slowly and the camera is ready to take
a picture with the remote control.
When the camera detects a person's
face, the Face Detection function is activated and the face detection
frame appears (p.71).
4
3
Point the remote control at the remote control receiver
and press the shutter release button on the remote
control.
The focus frame turns green when the subject is in focus and the
camera takes a picture at the following timing.
When i (3-sec Remote Control) is selected:
When h (0-sec Remote Control) is selected:
• The operating range is approx. 4 m (13 ft) from the front of the camera
when using the remote control unit.
• In C (Movie) and
shutter release button again stops the recording.
• The camera takes a picture even if the focus is not achieved.
• If the shutter release button on the camera is pressed halfway during
the countdown, the countdown stops. If the shutter release button on
the remote control is pressed again, the camera starts the countdown
again.
• i/hcannot be selected in 9 (Green) mode.
• The self-timer lamp does not flash in e (Pet) mode.
98
The self-timer lamp and the macro lights blink quickly and the
camera takes a picture after about three seconds.
The camera takes a picture immediately.
(Underwater Movie) modes, pressing the
Drive Mode Drive Mode Drive Mode
Remote Control Remote Control Remote Control
Cancel Cancel Cancel
MENU MENU MENU
OK OK OK
OK OK OK