Pentax Optio Optio WG-1 GPS Quick Manual

Thank you for purchasing this PENTAX digital camera.
The Optio WG-1 GPS / Optio WG-1 is waterproof, dustproof,
and shockproof, as shown below, so you can use it in a
wide range of outdoor activities.
Waterproof/dustproof: JIS grade 8 waterproof and grade 6
dustproof (IP68)
Shockproof: Satisfies Pentax drop test (1.5 m height onto
a 5 cm thick plywood surface) complying with MIL-
Standard 810F Method 516.5-Shock testing.
* Waterproof performance is not guaranteed if the camera
is exposed to impact such as being dropped or hit.
* The camera is not guaranteed to be free of trouble or
damage under every condition.
1
1 Preparing the Camera for Use
Prepare your camera for use before you begin
using it.
Attaching the
Carabiner Strap
Attach the carabiner strap
supplied with the camera
as shown in the illustration.
Installing the Battery
and SD Memory Card
Battery/
card cover
Install the battery and SD
Memory Card as shown in
the illustration.
Battery/card
cover lock lever
Battery
SD Memory Card socket
lock lever
SD Memory Card
Battery
* The SD Memory Card is sold separately.
The inside of the battery/card and terminal covers are not waterproof
In locations where the camera is exposed to water or dirt
such as underwater, at the beach, in a kitchen, etc., make
sure that the battery/card and terminal cover lock levers are
firmly locked so that they won't open unexpectedly. Do not
open the covers in such locations.
When removing the battery or card, avoid surroundings where
the camera may be exposed to water or dirt, and make sure the
camera, battery, card, and your hands are completely dry.
Checking the Contents of the Package
Check that your camera comes complete with
the items listed below.
Camera (Optio WG-1 GPS / Carabiner strap
Optio WG-1) (O-ST117/O-ST118)
Software (CD-ROM) USB cable (I-USB7)
S-SW117
AV cable (I-AVC7) Rechargeable lithium-ion
battery (D-LI92)
Battery charger (D-BC92) AC plug cord
Strap (O-ST104) Macro stand (O-MS1)
Operating Manual Quick Guide (this guide)
Utilities Guide for GPS (WG-1 GPS only)
2
2 Turning the Camera On
Press the power switch.
The camera turns on and is ready to take
still pictures. Press the power switch
again to turn the camera off.
Make the Initial Settings.
The [Language/ ] screen appears when the camera is turned on for
the first time. Select the desired language and then set the date and time.
1
Use the four-way controller
2 345
( ) to select the desired
language.
2 Press the 4 button.
The [Initial Setting] screen
MENU Cancel
appears.
Memo
If you accidentally select the wrong
Initial Setting
language and press the 4 button,
5 English
press the four-way controller ( ), use
2 345
Hometown
the four-way controller ( ) to
New York
select the desired language, and then
Settings complete
press the 4 button. The [Initial
MENU Cancel
Setting] screen appears in the selected
language.
Names of Parts and Monitor Indicators
Front
Shutter release button
Power switch/Power lamp (green)
Macro light
Back
Terminal cover
lock lever
Terminal cover
HDMI terminal
PC/AV terminal
2
In this Quick Guide,
the arrow keys to
4 5
be pressed are
indicated as shown
on the right.
3
3
3
Press the four-way controller ( ) to
Initial Setting
move the frame to [W Hometown].
MENU
5
4
Press the four-way controller ( ).
The [W Hometown] screen appears.
MENU
45
5
Use the four-way controller ( ) to
choose a city.
3
6
Press the four-way controller ( ) to move the frame to [DST]
(Daylight Saving Time).
45
7
Use the four-way controller ( ) to select
the 4 button.
OK OK
The [Initial Setting] screen reappears.
3
8
Press the four-way controller ( ) to select [Settings complete]
and press the 4 button.
The [Date Adjustment] screen appears.
9
Press the four-way controller
Date Adjustment
5
DST
OFF OFF OFF
( ) to select [mm/dd/yy], then
use the four-way controller
2 3
( ) to choose the date
format.
MENU
Monitor Indicators
Following indicators are displayed in the still picture capture mode.
Normal display in the Still Picture Capture Mode
Flash
Drive mode Focus mode
Lens
Flash mode
Speaker/Microphone
Shooting mode
Battery level
Remote control
P
Face Detection
receiver
Date imprint
Self timer lamp/
setting
Focus assist
DATE
EV
Display
+ 1 . 0
compensation
1 / 2 5 0
Shutter speed
Tripod socket
F 3 . 5
Aperture
Battery/card cover
Camera shake 3 8
lock lever
reduction
Battery/card cover
Memory status
Built-in memory
(without card)
SD Memory Card
Card is write-protected
Battery lock lever
Battery Level Indicator
You can check the battery level by the
Screen Display
(green) Adequate power remains.
(green) Battery is running low.
(yellow) Battery is running very low.
(red) Battery is exhausted.
[Battery depleted] The camera turns off after this message appears.
10
Press the four-way controller (
the four-way controller (
English
display) or [12h] (12-hour display).
Hometown
New York DST
OFF OFF OFF
11
Press the four-way controller (
Settings complete
3
controller ( ) to move the frame to [Date].
Cancel
12
Hometown Press the four-way controller (
(day) or [2011] (year), then use the four-way controller (
to set the current date and time.
City New York
13
Press the four-way controller (
DST
3
Cancel OK OK controller ( ) to move the frame to [Time].
14
Set the time in the same manner as in
15
Press the four-way controller (
to select [Settings complete] and
press the 4 button.
O P
or and press
Formatting an SD Memory Card
Use this camera to format (initialize) an SD Memory Card that is
unused or has been used on another camera or digital device.
Date Format mm/dd/yy 24h
Be aware that formatting will delete all the data stored in the SD
Date 01/01/2011
Memory Card. For how to format an SD Memory Card, refer to
Time 00:00
the Operating Manual (p. 230).
Settings complete
Cancel
Continue on the reverse side.
Eye-Fi communication status
Digital zoom icon
Positioning status
GPS GPS GPS
' 11 / 0 2 / 0 2 ' 11 / 0 2 / 0 2 ' 11 / 0 2 / 0 2 1 4 : 2 5 1 4 : 2 5 1 4 : 2 5
Focus frame Date and
time
D-Range Setting
World Time setting
Remaining image
No icon Hometown :
storage capacity
: Destination
indicator on the display.
Battery Status
5
) to select [24h], then use
2 3
) to select [24h] (24-hour
5
), then press the four-way
5
) to select [01] (month), [01]
2 3
)
5
), then press the four-way
12 .
3
) Date Adjustment
Date Format mm/dd/yy 24h
Date 01/01/2011
Time 00:00
Settings complete
MENU Cancel OK OK