Calibration Editing
Star A211 and Star 321 Meters Only
2. Press
3. Press
to proceed to the measurement mode, press f2 (print)
printer or computer or press f3 (cal edit) to edit another calibration point.
RmV Calibration
instructions in the electrode use guide. Connect the electrode and any other electrodes to be used (stirrer probe, ATC probe,
Note: In most calibration screens, press f1 (esc) to return to the measurement mode without saving the calibration.
the standard.
3. When the electrode and standard are ready, press f3 (start)
f3 (start) is pressed and stop stirring once the reading stabilizes.
a. Press f2 (accept)
b.
f1 (meas) to proceed to the measurement mode or press f2 (print)
the data to a printer or computer.
16
or
to highlight the calibration point to be edited and press f2 (select).
or
to highlight Remeasure, Edit or Delete and press f2 (select).
Remeasure
Edit is selected, press f3 (edit)
(done) and then press f2 (accept). Select another calibration point to edit or press f1 (back).
Delete
calibration to a one point calibration, enter the slope using the numeric entry screen.
f1 (cal).
Press f3 (edit)
i. Press
,
,
or
ii. Press f2 (done)
iii. Press f2 (accept) to accept the entered mV value.
Thermo Scientific Orion Star A211 Benchtop and Star A221 and Star A321 Portable pH Meter Reference Guide
press f3 (cal edit) to edit the calibration points.
Rel Value line.
to highlight a number, decimal point or negative sign; press f3 (enter) to select the
stabilizing or solid ready icon, and perform
Rel Value line.
f2
f1 (meas)