Special Programming - Panasonic KX-TG6561E Operating Instructions Manual

TG6561E(e).book Page 28 Tuesday, July 13, 2010 1:50 PM
Programming

Special programming

Alarm
An alarm sounds at the set time for 3
minutes once or daily. Alarm can be set
for each handset.
Important:
L Set the date and time beforehand
(page 14).
1
8 i {#}{7}{2}{0}
2
{V}/{^}: Select the desired alarm
option. i M
"Off"
Turns alarm off. Go to step 6.
"Once"
An alarm sounds once at the set
time.
"Daily"
An alarm sounds daily at the set time.
Go to step 4.
3
Enter the desired date and month.
i M
4
Set the desired time. i M
5
{V}/{^}: Select the desired alarm
tone. i M
L We recommend selecting a
different ringer tone from the one
used for outside calls.
6
M i {ic}
L When the alarm is set, E is
displayed.
Note:
L To stop the alarm, press any dial key
or place the handset on the base unit
or charger.
L When the handset is in use, the alarm
will not sound until the handset is in
standby mode.
28
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
Changing the handset name
Each handset can be given a
customised name ("Bob", "Kitchen",
etc.). This is useful when you make
intercom calls between handsets. You
can also select whether or not the
handset name is displayed in standby
mode. The default setting is "Off". If
you select "On" without entering any
handset name, "Handset 1" to
"Handset 6" is displayed.
1
8 i {#}{1}{0}{4}
2
Enter the desired name (max. 10
characters; page 42).
L If not required, go to step 3.
3
M
4
{V}/{^}: Select the desired setting.
i M 2 times
5
{ic}
Incoming call barring (Caller
ID subscribers only)
This feature allows the unit to reject calls
from specified phone numbers that you
do not want to answer such as junk calls.
When a call is received, the unit does not
ring while the caller is being identified. If
the phone number matches an entry in
the call barred list, the unit sends out a
busy tone to the caller, and then
disconnects the call.
Important:
L When the unit receives a call from a
number that is stored in the call barred
list, the call is logged in the caller list
(page 31) with 7 after the call is
disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in
the call barred list by using the caller list
or by entering the numbers directly.