Andrew 3.7-Meter Earth Station Antenna Installation And Operation Manual page 59

Step 5
Align the enclosure bracket to the ground mount assembly. The left bolt should be
inserted to hold reflector in place using 3/4" A-325 hardware (hex bolt, flatwasher and
nuts as shown in Figure 3-47 and Figure 3-48.
Step 6
Have the two people on the ground rotate the reflector to connect with the right bolt of
the enclosure bracket against the ground mount angle bracket. Facing the reflector, the
right bolt should be inserted to hold the reflector in place using the appropriate hard-
ware.
Figure 3-47: Enclosure Bracket
Figure 3-48: Enclosure Bracket Alignment
59
Installation Procedures