Andrew 3.7-Meter Earth Station Antenna Installation And Operation Manual page 30

Step 10
The next step is to install the elevation strut assembly. Begin by bolting the elevation strut
tube assembly (P/N 205872) to the ground mount assembly as shown in Figure 3-19.
Step 11
Bolt the elevation bracket-support plates (P/N 205873) to the elevation strut tube assem-
bly using 5/8 inch hardware (hex bolt, flatwasher and nut)as shown in Figure 3-20.
Figure 3-19: Elevation Strut Pick Up Assembly (Top View)
Figure 3-20: Bracket-Support Plates (Top View)
30
Installation Procedures