Recommended Tools - Andrew 3.7-Meter Earth Station Antenna Installation And Operation Manual

Recommended
Tools
NOTE: Failure to follow an installation procedure could result in damage to equipment
or personal injury.
Additional warnings will be displayed throughout this manual for your awareness. These
warnings can be identified in warning boxes as shown in the following sample.
Andrew disclaims any liability or responsibility for the results of improper or unsafe
installation, operation, or maintenance practices.
Andrew supplies all appropriate hardware/parts required for the installation of your 3.7-
Meter Earth Station Antenna. All tools necessary for the installation process should be
provided by the installation crew. Andrew recommends the following tools to be used for
a proper installation of the 3.7-Meter Earth Station Antenna.
Tool
Open End or Combination Wrenches
Crane
Nylon Web Slings (2000 pound breaking strength) 3 Inch by 14 Foot
Rope or Cord (2000 pound breaking strength)
Shackles
Ladder
Drive Sockets
Breaker Bar
Spud Wrenches
Screw Driver
Allen Wrench
Tape Measure (or other measuring device)
Felt-tip Marker (or other marking device)
Hammer
Rubber Mallet
Pry Bar
Tin Snips
Safety Gloves (each installer)
Size
5/16 Inch
7/16 Inch
9/16 Inch
7/8 Inch
3/4 Inch
1/2 Inch
1-1/4 Inch
1 Ton Minimum Capacity, extended end
50 Foot
5/8 Inch
10 Foot Extension
1/16 Inch
9/16 Inch
7/8 Inch
3/4 Inch
1-1/4 Inch
1/2 Inch
1-1/16 Inch
1-1/4 Inch
Standard
Phillips
7/64 Inch
3/16 Inch
1/4 Inch
Standard
Standard
Standard
Standard
Standard
Standard
Standard
Table 2-1. Recommended Tools
7
Quantity
2
2
2
2
2
2
1
1
2
1
2
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
Getting Started