Andrew 3.7-Meter Earth Station Antenna Installation And Operation Manual page 37

Step 10
Loosen the clamp on the jack boot.
Step 11
Unscrew the jack by using a spud wrench until the jack connects to the back of the
enclosure as shown in Figure 3-28c.
Step 12
Tighten the hardware using the A-325 tensioning procedure.
Step 13
Lubricate the jackscrews using the maintenance procedures.
Step 14
Pull the protective boot over the jackscrew, and clamp it at the end as was performed
with the azimuth jackscrew.
Figure 3-28b: Elevation Jack
Figure 3-28c: Elevation Jack Extension
37
Installation Procedures