Table of Contents
Advertisement
Floppy disk inserting slot
(2) Precautions in handling floppy disks
Do not place the floppy disk near
an ashtray or food and drink.
Do not bring the floppy disk close
to a magnetized material.
(3)
When the threader and sewing machine are switched ON, sew the desired sewing pattern with the thread tension
disk closed. Once, you have completed the thread trimming, the thread tension disk will open.
Before sewing a new pattern or using a new feeding frame (small), be sure to check the contour of the pattern for
the relation between the feeding frame and the pattern.
Be sure to check for a cause of trouble and take a proper corrective measure when the error indicator lamp lights
"P.
Do not draw , by hand, the material being sewn during sewing. Doing so will cause the needle shift from the
correct position. If the needle moves from the correct position in terms of the X/Y direction, press the [Enter1 key
twice. This will return the needle to the normal origin.
Insert the floppy disk in the control box only when the pattern reading is made. Take it out when the machine is
normally
operated.
Face A
Eject button
1) Loading the floppy disk
After turning the power switch ON, slowly insert the
floppy disk, with its face A looking to the upper as
observed from you, until the eject button pops out.
2) Unloading the floppy disk
After the reading of the floppy disk is over, press the
eject button and take out the floppv disk.
3) Write-protect hole
When the wtite-protect
tab is moved to open the write-
protect hole, no data is allowed to be written into the
disk. Use for retaining the programmed data.
For writing data into the disk, move the write-protect
tab until it is exoosed.
(Caution)
Never turn the power switch ON or OFF with the
floppy disk mounted.
Do not touch the exposed parts of
the floppy disk.
Do not place the floppy disk in a hot
place (51% or higher) or a place
exposed to direct sunlight.
Advertisement
Table of Contents
