Pin Assignment; 12-Pin Multi-Connector (Dc-In/Trigger); Bnc Connector For Analogue Monitor Video Output; Digital Output Connector For Camera Link - JAI CV-M2 Operation Manual

5. Pin Assignment

5.1. 12-pin Multi-connector (DC-IN/Trigger)

Type: HR10A-10R-12PB-01
(Hirose) male.
(Seen from rear of camera.)
1 9
2
8
10
3 11 7
12
4
6
5
Fig. 2. 12-pin connector.

5.2. BNC connector for analogue monitor video output

On the BNC connector an analogue video signal (CCIR or EIA) for monitoring is found if OS=2. The
signal can be viewed on a standard monitor as 50 FPS/15.734 kHz 290 lines if MN=1, or 60
FPS/15.734 kHz 240 lines if MN=0. It is non-interlaced and for single channel only. The image
covers the full format, but the resolution is much lower than the digital video output.

5.3. Digital Output Connector for Camera Link

13
26
Fig. 3. Camera Link connector
The digital output signals follow the Camera Link standardized multiplexed signal output
interface. The output driver is NS type DS90CR285, and the receiver is NS type DS90CR286.
The following signals are found on the Digital Output Connector:
SerTC
SerTFG
CC1
CC2
X0 to X3
Xclk
In the Channel Link X0 to X3 multiplexed signals the following signals are encoded.
D0 – D9
LVAL
FVAL
DVAL
EEN
LVAL, FVAL, DVAL polarity is positive. EEN is negative. TRIG is negative as factory setting. TRIG
polarity can be changed by TP. For Camera Link interface principle diagram please check Fig. 7.
CV-M2
Pin no.
1
2 +12 V DC input
3
4 Iris Video output
5
6
7
8
9
10 Trigger/SG input
11 Factory use
12
*) Refer to 5.4.2. for Iris video output. SG = Sensor Gate Control.
Type: 26 pin MRD connector
1
3M 10226-1A10JL
14
RXD serial data to camera
TXD serial data to frame grabber
Trigger/Sensor Gate input
Factory use
Camera Link multiplexed data out
Camera Link clock. Used as pixel clock.
2 x 10 bit video data out for right and left channel.
Line VALid. Video line data is valid.
Frame VALid. Video frame data is valid.
Data VALid. Effective video pixel data is valid
Exposure ENable.
(Not specified by Camera Link).
Signal Remarks
GND
GND
Analogue video for iris control in
continuous mode and RCT mode. *)
GND
RXD in
RS 232C. Or via Camera Link
TXD out By internal switch HR/CL (Refer to 7.2)
GND
EEN out
Or via Camera Link
TI=1. (Or via Camera Link if TI=0 )
SG=0 trigger input. SG=1 sensor gate contr.
For factory test
GND
(Int. switch HR/CL. Refer to 7.2)
(Int. switch HR/CL. Refer to 7.2)
(TI=0 for CL. SG=1 for Sensor Gate)
- 4 -