Configuring The Camera; Mode Setting Sw1 On Rear; Rs-232C/Camera Link Switch; Internal Switch - JAI CV-M2 Operation Manual

7. Configuring the Camera

7.1. Mode setting SW1 on rear

Switch SW 1.1 on the camera rear can be used to select digital or analogue video out. SW1.1 has
higher priority than RS-232C.
SW1.2 is for termination of the trigger 1 input on pin #10 Hirose.
(SW1.3 is for termination of the factory test input on pin #11 Hirose)
SW1.4 is for master gain selection. SW1.4 has higher priority than RS-232C.
Fine gain adjustment on R channel by RS-232C.

7.2. RS-232C/Camera Link switch

The internal switch HR/CL can be used to select the control input via the 12 pin Hirose as RS-
232C or via Camera Link. Factory setting is Camera Link. The switch is placed inside the camera
on the motherboard.

7.3. Internal Switch

The switch is placed inside the camera on the motherboard.
CV-M2
SW 1 SW 1
1 1
Video out Video out
Trig 1 term. Trig 1 term.
2 2
Factory use Factory use
3 3
Gain Gain
4 4
Fig. 30. SW1 on camera rear
1 1
RS- 232C RS- 232C
NC NC
2 2
Fig. 31. Internal Switch
SW SW
Fig. 32. Internal switch
- 26 -
Digital < > Analog Digital < > Analog
TTL < > 75Ω TTL < > 75Ω
TTL < > 75Ω TTL < > 75Ω
RS-232 < > potm. RS-232 < > potm.
Hirose < > Camera Link Hirose < > Camera Link
< > < >