Figure 4: Mounting The Galil 4-C Closed-Back Ceiling Speaker - Kramer Galil 4-C User Manual

T-channel Grid
Support Ring
Screws

Figure 4: Mounting the Galil 4-C Closed-back Ceiling Speaker

2. Place the tile rails on the tile and snap them into the two tabs on the C-ring.
Align the rails so that the ends extend over the T-channel grid.
3. Insert a screw through each tab on the C-ring to secure the rails.
4. Connect the speaker wires to the appropriate connector terminals:


Screw the hold-down screws on the connector until tight, using a small
screwdriver.
You can connect the speakers in the two following possible layouts:


5. Plug the connector into the socket (see
6. Run the wires through the opening in the input terminal cover and then
connect to the speaker terminal block connector.
Galil 4-C Installing the Galil 4-C
Ceiling Tile
PIN 1 and PIN 2 are connected internally and are positive (+)
PIN 3 and PIN 4 are connected internally and are negative (-)
Wiring in parallel: connect the amplifier directly to each of the
speakers. When one input connector is removed, subsequent
speakers will remain connected (see
Daisy-chaining: connect the wire pair (+ and -) of the speaker to the
subsequent speaker + and -. When one input connector is removed,
subsequent speakers will be disconnected (see
Tile Rails
Figure 3)
Figure
Figure 5).
C-ring
3)
9