1. Manuals
  2. Brands
  3. Anton/Bauer Manuals
  4. Lighting Equipment
  5. ULTRALIGHT UL-S
  6. Owner's manual

Anton/Bauer ULTRALIGHT UL-S Owner's Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Approved Copy
®
ULTRALIGHT® SYSTEM
A7595-0086 Rev N

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ULTRALIGHT UL-S and is the answer not in the manual?

Questions and answers

Related Manuals for Anton/Bauer ULTRALIGHT UL-S

Summary of Contents for Anton/Bauer ULTRALIGHT UL-S

  • Page 1 Approved Copy ® ULTRALIGHT® SYSTEM A7595-0086 Rev N...

  • Page 2: Table Of Contents

    Approved Copy TABLE OF CONTENTS INTRODUCTION QUICK CHANGE HEAD MODULE REMOVAL OF HEAD MODULE PROPER BULB REMOVAL/REPLACEMENT GOLD MOUNT SNAP ON BATTERY BRACKET ® ULTRALIGHT FILTER ACCESSORIES ® ULTRALIGHT DIMMER ACCESSORIES ® MOUNTING FILTERS 12V BULB SELECTION 30V BULB SELECTION SPECIFICATION SERVICE LIMITED WARRANTY...

  • Page 3: Introduction

    Approved Copy NEVER attempt to remove or install a bulb while Head Module is attached to the base or install a bulb directly into the socket/base assembly. INTRODUCTION The Ultralight is an extremely compact, lightweight, portable lighting system with almost total versatility. Weighing only 13 ounces, the quick- ®...

  • Page 4: Removal Of Head Module

    Approved Copy REMOVAL OF HEAD MODULE IMPORTANT: The Head Module must be removed before attempting to change any bulb. CAUTION: Head Module may be hot if the light has just been turned off. For proper Head Module removal, follow these instructions. 1.

  • Page 5: Proper Bulb Removal/Replacement

    Approved Copy PROPER BULB REMOVAL /REPLACEMENT For proper removal/replacement: 1. Follow the instructions on the previous page to remove the Head Module from the base of the light. 2. Using your thumbs, pull out on the hood tabs (see diagram) and rotate hood upwards. 3.

  • Page 6: Ultralight Filter Accessories

    Approved Copy ULTRALIGHT FILTER ACCESSORIES ® Ultralight adapter accessories are detachable pivoting filter/lenses allowing the user to flip the adapter in and out of the beam pattern. Adapters ® (Diffuser, Wide Angle, Dichroic) are mounted in a holder, pivoted from a slotted tab into the space between the light head safety glass holder and the hood.

  • Page 7: Ultralight ® Dimmer Accessories

    Approved Copy ULTRALIGHT ACCESSORIES (AVAILABLE SEPARATELY) ® ULTRALIGHT DIMMER ® The ULTRALIGHT DIMMER (UL Dimmer) can be mounted on all camera/camcorders via either the Shoe Mount or ¼-20 Stud Mount. Note: ® The UL2 that will be mounted on the UL Dimmer needs to have the ¼-20 Stud Mount installed. This is supplied with every UL2 light. Please reference the UL2 Owners Manual.

  • Page 8: Mounting Filters

    Approved Copy OPERATING INSTRUCTIONS Adjusting the UL Dimmer: - Use the dial to adjust the dimmer from 0 to 100% - Turn clockwise toward 100% - Turn counter clockwise toward 0% Programming the Presets To Reset: - To Reset the preset, press & hold the dial inward for 4 seconds. To Set Presets: - To set a low preset, adjust light to the desired low end output and press the dial inward.

  • Page 9: 12V Bulb Selection

    Approved Copy 12v BULB SELECTION Bulbs used by the Ultralight are Type MR16, tungsten-halogen bulbs. Spot or flood bulbs of any light distribution angle may be used. Low ® Voltage Bulbs – 12 to 14.4 volts. The Ultralight offers the greatest versatility with the following low voltage bulbs. They can be powered from any 12-14.4 volt camera battery ®...

  • Page 10: Specification

    Approved Copy SPECIFICATION LAMPS Type MR-16 12-14 Volts, 25-85 Watts MAX. CURRENT 8 amps; 200 Watts, 4-6 amp Typical for Single Bulb WEIGHT Single Base unit w/o bulb: 13 oz. Dual Base unit w/o bulb: 19 oz. SIZE Light Head Module: 2-1/4”W x 2-1/2”H x 2-13/16”...

  • Page 11: Limited Warranty

    Approved Copy LIMITED WARRANTY United States District Court for the District of Connecticut, or in any This one (1) year limited warranty for the product specified in this Superior Court in Fairfield County, Connecticut, USA. Some states do document (“Product”) is given by Anton/Bauer, Inc. (“Anton/Bauer”), not allow limitations on how long a warranty lasts, so the time period 14 Progress Drive, Shelton, Connecticut 06484.
  • Page 12 Approved Copy The following are trademarks of Anton/Bauer, Inc.: Anton/Bauer, Anton/Bauer logo and parallelogram design, Aspekt, Automatique, DataTap, DIONIC, Elipz, Egripz, Elightz, Essentialz, Gold Mount, HubZ, HyTRON, Impac, Interactive and design, LifeSaver, Logic Series, Logic Series Logo, Maxx man logo design, Nexus, PowerStrap, Proformer, Probe, ProPac, RealTime, Satellight, Snap-On, Stasis, Stasis Flex, Tandem, TrimPac, Ultrakit, Ultralight, “One World.

This manual is also suitable for:

Ultralight ul-d

Table of Contents