Anton/Bauer DUAL 2722 Owner's Manual
  1. Manuals
  2. Brands
  3. Anton/Bauer Manuals
  4. Battery Charger
  5. Interactive 2000 PowerCharger
  6. Owner's manual

Anton/Bauer DUAL 2722 Owner's Manual

Charger / power supply
Hide thumbs Also See for DUAL 2722:
Table of Contents

Advertisement

Quick Links

See also: Owner's Manual , Operating Instructions
Approved Copy
®
DUAL 2722
BATTERY SYSTEM
A7595-0231 Rev J

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DUAL 2722 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Anton/Bauer DUAL 2722

Summary of Contents for Anton/Bauer DUAL 2722

  • Page 1 Approved Copy ® DUAL 2722 BATTERY SYSTEM A7595-0231 Rev J...

  • Page 2: Table Of Contents

    Approved Copy TABLE OF CONTENTS INTRODUCTION FEATURES SAFEGUARDS GROUNDING/EARTHING OPERATION Charging Applications Three Stage Charging Methodology LED Indications LCD Indications DDM (DIAGNOSTIC/DISCHARGE MODULE) To Operate The DDM “AUTOCAL” Feature OPERATION AS DC CAMERA SUPPLY FROM MAINS FCC NOTICE SPECIFICATIONS FUSE TYPE/REPLACEMENT WARRANTY...

  • Page 3: Introduction

    Approved Copy INTRODUCTION SAFEGUARDS The DUAL 2722 is a simultaneous 2 position Interactive 2000 Power Sources: This unit was designed to operate at mains voltages ® PowerCharger fast charger with 70 watt DC camera power supply. from 100 - 240 Volts AC, 50-60 Hz.

  • Page 4: Operation

    Approved Copy OPERATION CHARGING THREE STAGE CHARGING METHODOLOGY In general, the DUAL 2722 will deliver a three stage charge routine As with all Anton/Bauer chargers, charging with DUAL 2722 is fully to each battery. automatic. Mount any Digital Logic Series...

  • Page 5: Led Indications

    LED INDICATIONS The DUAL 2722 has two sets of two LEDs (one red, one green) and one green status LED in the center. The green status LED indicates: Steady green – line voltage is present; Off – line voltage not present.

  • Page 6: Lcd Indications

    Approved Copy OPERATION CONTINUED LCD INDICATIONS Each PowerCharger’s liquid crystal display (LCD) will display the status of each battery, as well as, important PowerCharger operating ® ® indications. The following information explains the indications which appear in the LCD. The levels of the LCD display on each PowerCharger can be obtained by pressing the DISPLAY, or in some cases TEST, button on the ®...

  • Page 7: Ddm (Diagnostic/Discharge Module)

    Approved Copy DDM (DIAGNOSTIC/DISCHARGE MODULE) A standard feature with the DUAL 2722, the DDM completes a 3. Hold the TEST button as the unit beeps 3 times. Release the button battery management system, capable of testing battery capacity and and the unit will indicate that the test mode has been selected. This identifying battery anomalies before they appear in the field.

  • Page 8: Autocal" Feature

    OPERATION AS DC CAMERA FUSE/TYPE REPLACEMENT SUPPLY FROM MAINS The fuse of the DUAL 2722 is a PCB mounted device which should only be replaced by a qualified service technician. The DUAL 2722 can operate cameras and camcorders using the four pin camera output connector located on the back of the DUAL 2722.

  • Page 9: Limited Warranty

    Product. er”), 14 Progress Drive, Shelton, Connecticut 06484. If you (the pur- chaser of the Product from Anton/Bauer, or the person for whom the ANTON/BAUER DISCLAIMS ANY LIABILITY FOR INCIDENTAL OR Product was purchased, if it was a gift) have any questions regarding...
  • Page 10 Approved Copy The following are trademarks of Anton/Bauer, Inc.: Anton/Bauer, Anton/Bauer logo and parallelogram design, Aspekt, Automatique, DataTap, DIONIC, Elipz, Egripz, Elightz, Essentialz, Gold Mount, HubZ, HyTRON, Impac, Interactive and design, LifeSaver, Logic Series, Logic Series Logo, Maxx man logo design, Nexus, PowerStrap, Proformer, Probe, ProPac, RealTime, Satellight, Snap-On, Stasis, Stasis Flex, Tandem, TrimPac, Ultrakit, Ultralight, “One World.

Table of Contents