Anton/Bauer DIONIC 90 Owner's Manual
Lithium ion digital battery interactive battery system
Hide thumbs
Also See for DIONIC 90:
- Owner's manual (24 pages) ,
- User manual (24 pages) ,
- Operating instructions (3 pages)
Subscribe to Our Youtube Channel
Related Manuals for Anton/Bauer DIONIC 90
Summary of Contents for Anton/Bauer DIONIC 90
- Page 1 Approved Copy ® DIONIC® 90 Lithium ion Digital Battery BATTERY SYSTEM A7595-0243 Rev U...
-
Page 2: Table Of Contents
Approved Copy TABLE OF CONTENTS IMPORTANT READ AND UNDERSTAND THIS MANUAL BEFORE OPERATION INTRODUCTION FEATURES CHARGING DIONIC 90 BATTERIES ® NOMINAL CHARGE TIMES FOR DIONIC ® 3-4 REALTIME DISPLAY INDICATIONS ® 4-5 OPERATING GUIDELINES SERVICE PRECAUTIONS DIONIC 90 BATTERY SPECIFICATIONS ® WARRANTY – InterActive Dionic 90 Battery: ® TRANSPORTATION NOTICE:... -
Page 3: Introduction
Dual, ABC800 cannot charge these batteries. ® Do not attempt to charge on non InterActive chargers or chargers not manufactured by Anton/Bauer. Special safety circuits in the DIONIC 90 battery will prevent charging on ANY charger, which cannot properly address the battery ®... -
Page 4: Features
Note: On some older chargers it may be necessary to install battery 6. Individual Computer Testing – As with all Anton/Bauer batter- on charger, wait one (1) minute, then remove battery and re-install. ies, each and every InterActive DIONIC 90 battery is individually This procedure may need to be repeated more than once to “wake ® tested to assure optimum capacity, voltage and overall quality. up” a low voltage battery. A serialized computer performance graph as confirmation of this testing is enclosed. NOMINAL CHARGE TIMES FOR DIONIC 90 Charge Level LED Indicators 90% Flashing Green 100% Steady Green DUAL 2722 (2 batteries simultaneously) 2hrs. 3hrs. InterActive PowerCharger 2 hrs. 3 hrs. (QUAD/DUAL – 2702/2701/2700) (QUAD/DUAL – 2401/2400) T2 (2 batteries simultaneously) 2hrs. - Page 5 BAR: Indicates 25% - 50% the present load on the battery. BAR: Indicates 7% - 25% • If no load is detected, or if the battery is removed from the char- ger before any discharge load is applied, the default assumed INTERACTIVE 96 - 100% power for remaining run time calculations is 20 Watts. RES BAR: Indicates 0 - 6% 1. “INTERACTIVE” SEGMENT: When illuminated, it indicates • When the battery determines that a load is attached, remain- the DIONIC 90 battery has completed its full charge routine. ® ing run time will be calculated based on that load and the time remaining will be updated. 2. “RES” Bar: Is the last “Fuel Gauge” Bar and will start to flash at 6% capacity and will continue to flash until EOD is reached. • The battery will “learn” this new load and retain that load informa- tion in non-volatile memory. If the battery is removed from the 3. “SERVICE” SEGMENT: Indicates self-diagnostic functions camera it will retain this information for 30 minutes or until it is have detected anomalies. A battery with a “Service” flag returned to the charger or sees a new load. After 30 minutes the should be returned to the Anton/Bauer Service Department. battery will return to the default load of 20 watts. 4. “SIDE BAR” SEGMENTS: Will remain ON (see diagram above).
-
Page 6: Operating Guidelines
Approved Copy LCD DISPLAYS (CONT.) OPERATING GUIDELINES • OVERCURRENT INDICATION If the DIONIC 90 battery is 1. Keep batteries cool or at room temperatures whenever pos- ® subjected to a load that exceeds specifications, the protection sible. Sustained elevated temperatures are the primary reason for electronics will operate to protect the lithium ion cells. All status premature failure of lithium ion batteries: icons on the LCD will flash at a once per second rate. This can occur, for example, if a cold halogen light =/>75 watts is a. Charging - Charge batteries at room temperature. In warm turned on. When the over-load condition is removed, the display... -
Page 7: Service
3. ALL LITHIUM ION BATTERIES have a finite life. If the battery exhibits noticeably shortened run time the battery should Anton/Bauer publishes a comprehensive “Video Battery Handbook” be replaced immediately. Shortened runtime is indicative of to help you further understand the care and use of video batteries. at least one cell, which has reached end of life. UNDER NO This guide is available at no charge by contacting Anton/Bauer at CIRCUMSTANCES attempt to “recondition”... -
Page 8: Limited Warranty
Product with any charging device or accessory not 1. MAIL WARRANTY REGISTRATION CARD or manufactured by and/or specified by Anton/Bauer. This warranty 2. REGISTER ON LINE AT www.antonbauer.com. does not cover, and Anton/Bauer assumes no responsibility for, any equipment or devices used in conjunction with the Product. Warranty registration, including the serial numbers of Anton/Bauer chargers used with this battery, must be supplied to Anton/Bauer. Anton/... - Page 9 AIR TRANSPORTATION DECLARATION DOT Dangerous Goods Regulations 49CFR Parts 100-185, International Air Transport Association (IATA) and the International Civil Aviation Organization (ICAO) rules apply to all lithium ion battery transport. Air Transportation Declaration Anton/Bauer, Inc. declares that the Dionic 90 lithium ion battery pack is rated 93-Wh and contains equivalent lithium content (ELC) in ® a quantity not exceeding 8 grams. This quantity is in compliance with IATA/IACO Dangerous Goods regulations Packing Instruction 965 (Special packaging required.) and DOT Dangerous Goods Regulations 49CFR Parts 100-185.
- Page 10 Approved Copy The following are trademarks of Anton/Bauer, Inc.: Anton/Bauer, Anton/Bauer logo and parallelogram design, Aspekt, Automatique, DataTap, DIONIC, Elipz, Egripz, Elightz, Essentialz, Gold Mount, HubZ, HyTRON, Impac, Interactive and design, LifeSaver, Logic Series, Logic Series Logo, Maxx man logo design, Nexus, PowerStrap, Proformer, Probe, ProPac, RealTime, Satellight, Snap-On, Stasis, Stasis Flex, Tandem, TrimPac, Ultrakit, Ultralight, “One World.
Need help?
Do you have a question about the DIONIC 90 and is the answer not in the manual?
Questions and answers