Table of Contents
Advertisement
Chapter 1 General Description
4.2
Front View (Without Front Bezel)
(8) Hard disk drive bay
The bay where HDD are installed. The sequential numbers
indicate the corresponding slot numbers. All bays include
Dummy Trays.
(9) DISK LED
The LED provided for each HDD.
This LED indicates hard disk drive status. (See page 5.)
(10) Pull-out Tab
A label indicating the part number and serial number of the
server is located on Pull-out Tab.
(11) USB connectors (front)
These connectors are used to connect devices that support
the USB interface.
(12) BMC RESET Switch
The switch to reset BMC of this server. Use the switch only
when there is a problem with EXPRESSSCOPE Engine 3
(BMC).
To use this switch, press it at least five seconds.
(13) RESET switch
Press this switch to reset the server.
(14) DUMP Switch (NMI)
When DUMP Switch is pressed, memory dump is
performed.
(15) Unit ID (UID) Switch/LED
The switch to turn on and off UID LED.
Pressing the switch once turns on UID LED and pressing
again turns off the LED.
Commands from the software also cause it to turn on or
flash. (See page 5.)
34
(16) POWER Switch/LED
The switch to turn the server on and off. Press once to turn
on the server. POWER LED lights when it is on. Press it
again to turn off the server. Hold down the switch for 4
seconds or longer to forcibly turn off the server.
(See page 5.)
(17) Display connector
Connect a display unit. This connector is exclusively used
with the display connector on rear panel.
(18) Optical disk drive bay
Bay to install an optical disk drive.
Either of the following drive can be installed.
– DVD-ROM drive
– DVD SuperMULTI drive
(19) 2.5-inch HDD cage bay
Bay to install an optional HDD cage N8154-41.
This bay is exclusively used with an optical disk drive.
Express5800/R120e-1M User's Guide
4. Names and Functions of Parts
See (3) to (5) on previous
page.
Advertisement
Table of Contents
