NEC Express5800/R120e-1M EXP291 User Manual page 77

Chapter 2 Preparations
Standby
Running
Standby
Running
Memory Sparing feature can be used under the following conditions:
•
DIMMs to be installed should have the same capacity.
•
See Chapter 2 (1. System BIOS) in "Maintenance Guide", check if your server supports Memory Sparing
feature.
Select Advanced → Memory Configuration → Memory Information, and check if Supported is
displayed in Sparing.
•
See Chapter 2 (1. System BIOS) in "Maintenance Guide", run SETUP, change parameters as shown
below, save the settings, and exit from SETUP.
Advanced → Memory Configuration → Memory RAS Mode → Change to Sparing.
•
After restart, run SETUP again, and check if "Spared" is displayed for the following parameter.
Advanced → Memory Configuration → Memory Information → CPUx_DIMMx Status
•
Installation order depends on CPU configuration. See the figure below.
Memory controller
Spare set Spare set
#1 #3
Memory controller
Spare set Spare set
#2 #4
Express5800/R120e-1M User's Guide
1. Installing Internal Optional Devices
Spare set Spare set
#5 #7
Spare set Spare set
#6 #8
77