When The Expected Images Are Not Projected; Turning The Power Off - Epson dreamio EH-R4000 User Manual

When the expected images are not projected

If more than one signal source has been connected, or if no images are projected, use the remote control or the
projector's control panel buttons to select the signal source. For video devices, press the [Play] button on the video
equipment first, then select the signal source.
Using the remote control
When the expected images are not
projected

Turning the power off

Press the button that has the name of the port on it that
the desired signal source is connected to.
When the color of the image projected
from the [Component] input port is
unnatural, select an appropriate signal
TIP
according to the signal from the device
connected at "Input Signal" in the
Configuration menu.
When the expected images are not
Turning the power off
projected
Turn the power off for the signal sources
Turning the power off
that are connected to the projector.
M
Press on the remote control or
the projector's control panel.
If "Standby Confirmation" in the configuration
menu is set to "On", the following message will be
displayed when you press
M
In such case, press
You can set whether or not to display the
confirmation message when
.
control is pressed
p.43
A
on
M
.
once more.
M
on the remote
p.43
Starting and Stopping Projection
Using the control panel
When you press B, the menu is displayed.
Each press of B moves the pointer. Move the
pointer to the target input source to select it.
The input source is automatically switched when no
operations are performed about three seconds with
placing pointer at the target input source. You can
also press F to switch to the target source.
Once the cool-down period (approximately 16
seconds) has ended and the operation indicator
has stopped flashing, turn off the main power
switch.
The projector will switch to standby mode when
M
or A is pressed. To completely turn off the
power for the projector, turn off the main power
switch. The projector still consumes power while it
is in standby mode.
Attach the lens cover.
If the projector is suspended from a ceiling and the
lens cover is left removed, the lens cover will still be
needed if the projector is moved anywhere, so keep
it in a safe place.
15