Replacing The Lamp - Epson dreamio EH-R4000 User Manual

Maintenance

Replacing the lamp

M
1
Press
off the power, and then
turn the main power switch
OFF.
* Wait until the lamp
cools down (takes
approximately 1 hour).
4
Loosen the lamp fixing
screws.
7
Securely tighten the
lamp fixing screws.
70
If the lamp stops working and needs to be replaced, there is the danger that the lamp
may already be broken.
If replacing the lamp of a projector which has been installed to the ceiling, you should
always assume that the lamp is broken and handle it with extreme care during
removal. Furthermore, you should stand to the side of the projector, not underneath it.
Wait until the lamp has cooled down sufficiently before removing the lamp cover. If the
lamp is very hot, you may get burned.
2
or A to turn
5
8
Loosen the lamp cover
fixing screw.
Remove the old lamp.
Pull out straight.
Install the lamp cover.
3
Remove the lamp cover.
6
Insert the new lamp.
Make sure that it faces
the correct way.
9
Tighten the lamp cover fixing
screw.