If The Target Image Is Not Projected; Turning Off The Power - Epson EH-TW6000W User Manual

Basic Operations

If the Target Image is not Projected

If the image is not projected, you can change the source using one of the following methods.
Remote control
Press the button for the target port.
c
•
For video equipment, start playback first and then change the source.
•
If the projector is suspended from a ceiling, after removing the lens cap, make sure you keep it in a safe
place as you will need to attach it when transporting the projector.
•
If the color looks unnatural when changing to a Video or Component source, check that the port you
have connected to is the same as the Input Signal.
Component p.63

Turning off the Power

a
Turn off the connected equipment.
b
Press the button on the remote
control or the projector's control
panel.
Remote control
A confirmation message is displayed.
Control panel
Control panel
Press the button and select the target port.
Press the button to confirm the selection.
Extended - Input Signal - Video Signal/
s
c
Press the
c
When Standby Confirmation is
set to Off, you can turn off the
projector by pressing the
button on the remote control
once.
Standby Confirmation
d
Wait until cool-down is complete.
The operation indicator on the projector's
control panel stops flashing.
e
Disconnect the power cable.
c
If the power cable is connected,
some electricity is consumed even
if no operations are made.
23
button again.
Extended - Display -
s
p.63