Rear; Base - Epson dreamio EH-R4000 User Manual

Part Names and Functions

Rear

The illustrations used here are of EH-R4000.
•
[Video] input port
Connects to the Composite
Video output port of the video
equipment.
•
[S-Video] input port
Connects to the S-Video out ports
of the video equipment.
•
[Component] input
port p.12
Connects to the
component (YCbCr
YPbPr ) out port of the
video equipment.
•
Power inlet
Connects the power cable.
•
Main power switch
p.14
•
[LAN] port
(EH-R4000 only)
Connects a LAN cable.
p.51
•
[PC] input port
Connects to the RGB out
port of the computer.
* Compatible with

Base

•
Filter cover opening
switch
Press this switch to replace
the internal air filter.
•
Cable cover stays
(2 places)
Attach the optional cable cover
here.
8
•
Cable holders
p.12
Attach the HDMI cable clamps to secure
HDMI cables to prevent the thick and
heavy cables from being disconnected
from the ports due to their own weight.
p.12
or
p.14
•
[HDMI1] input port*
p.12
Connects to an
p.12
TM
HDMI
video source or to a
computer.
HDCP
p.68
•
[HDMI2] input
port*
Connects to an
TM
HDMI -compatible
-compatible
video source or to a
computer.
HDMI cable clamp
(included)
•
Security lock
p.81
•
[Trigger out] port
Outputs a 12-volt DC
signal when the projector
is turned on. It is used to
transmit the power status
(on/off) or the aspect ratio
(Anamorphic Wide/Horiz.
Squeeze) of this projector
to external equipment
such as a motorized
screen.
•
[RS-232C] port
Connects to a computer
p.12
using an RS-232C cable
to control the projector
from the computer. This
is not used in normal use.
•
Suspension bracket fixing
points (4 points)
Install the optional ceiling mount
here when suspending the
projector from a ceiling.
p.72