Epson dreamio EH-R4000 User Manual page 43

Not displayed when image signals are being input from a computer.
Only displayed for Computer image input (does not appear when signals from the [HDMI1] /[HDMI2] input port are being input)
Mosquito NR (Mosquito Noise Reduction)
This reduces the noise which can be generated around the edges of images when projecting MPEG
images. Three modes are available. Select your preferred mode.
Block NR (Block Noise Reduction)
Set to "On" to reduce block noise which can occur when projecting MPEG images which have been
compressed at a low bit rate.
*1
Setup Level
(This can be set when NTSC signals are being input from the [Video] / [S-Video] input ports, or when
component video signals are being input from the [Component] input port.)
If using products designed for destinations such as South Korea that have different black level (setup
level) settings, use this function to obtain correct images. Check the specifications of the connected
equipment when changing this setting.
*1
EPSON Super White
(This can only be adjusted when the color mode is set to "Natural" or "Cinema" and signals are being
input via the [HDMI1]/[HDMI2] input ports.)
If bright white areas of images appear uneven and overexposed, set to "On".
When set to "On", the "HDMI Video Range" setting will be ignored.
*1
Overscan
(Setting is possible only when signals are being input from the [HDMI1]/[HDMI2]/[Component] input
port.)
• Off, 2%, 4%, 6%, 8%: If set to "Off", the top and the bottom of the image are sometimes affected by
• Auto: Displayed when the signals from [HDMI1] / [HDMI2] input port are being input. This is
automatically set to Off or 8%, depending on the input signal. (If the DVI port of the connected
equipment is connected to the [HDMI1] / [HDMI2] input port, "Auto" will not be displayed.)
*1
HDMI Video Range
(Setting is possible only when "EPSON Super White" is "Off". Setting is not possible, however, when
"Color Mode" is set to "x.v.Color".)
When the [HDMI1] / [HDMI2] input port of the projector is connected to a DVD player, for example,
setting this to Auto allows the projector to automatically determine and set the video range of the input
signal.
If this is set to Auto and a blackout/whiteout condition occurs, set the video range of the projector to
match that of the DVD player. The setting on the DVD player can be either Normal or Expand.
(If the DVI port of the connected equipment is connected to the [HDMI1] / [HDMI2] input port, "Auto"
will not be displayed.)
Reset
All the adjustment values on the "Signal" menu, except "Aspect ", are returned to their default values.
*1
*1
electrical interference depending on the image signal. In such cases, try to
adjust the display position ("Position").
*1 The setting values are stored separately for each image source and signal type.
Configuration Menu Functions
p.40
41