Replacing The Photocatalytic Filter; Storage - Mitsubishi Electric MJ-E20TX-H Instruction Manual

Replacing the
photocatalytic filter
The photocatalytic filter is disposable.
When it is time to replace the filter, please the replace
it with a new one.
When to replace it
Although photocatalytic filters last
roughly 2 years, please replace it in the
following cases:
¡ You have soaked the filter 8 times.
¡ The photocatalytic filter has turned
brown due to cigarette smoke or
black with dust.
Replacing
photocatalytic filter
For maintenance procedures see p.
1
Remove the pre-filter.
2
Replace the photocatalytic filter.
3
Attach the pre-filter.
Parts sold separately
Photocatalytic filter for replacement
∞ Type: MJPR-18TXFT
∞ Type code: 5C5 816
For these items contact your nearest Mitsubishi
Electric dealer.
The service of the photocatalytic filter may
vary depending on the operating
environment and conditions.

Storage

After switching the unit off, leave for about one day
until any water inside has had time to settle. Then carry
out the following steps.
1
Perform internal drying
Performing internal drying to prevent the growth of
mildew is recommended.
2
Hang on the cord hook.
11
3
Remove the drainage water.
4
Clean pre-filter.
5
Store the unit.
¡ When you are sure that all parts of the
unit are dry, cover it with a cloth to keep
it from dust.
¡ Store the unit in an upright position in a
place with low humidity, not exposed to
direct sunlight.
17
20
Empty the water
tank and wipe
away any
remaining drops
of water.
22
Remove grit
with vacuum
cleaner
23