Maintenance; Silver Ion Filter - Mitsubishi Electric MJ-E152AK-H Instruction Manual

Maintenance

Do not use detergents, cleaning agents for heat exchange equipment, decontaminative powders, chemically treated
cloth, gasoline, volatile oil, thinners, etc.
They can damage the water tank or main body, which may result in leakage.
When Cleaning the Unit
Wipe with a soft cloth.
Floating element
Do not remove or dismantle.
Because the dust in the air may cause the tank
lid and water tank to become dirty. If the dirt
cannot be removed, wash with water then wipe
with a dry cloth.
Mildew may form in the water tank when the dirt
is not removed thoroughly.
Pre-filter
Clogged pre-filter will reduce the
effectiveness of dehumidifying and
cleaning every two weeks is desirable.
How to remove and attach the filter
1
Remove the pre-filter.
2
Remove the silver ion filter.
3
Clean the pre-filter.
4
Set the silver ion filter.
Make sure the silver ion filter is attached to
the unit. If it is not, fine dust will enter into
the unit and cause malfunctions.
5
Set the pre-filter.
24
Use a vacuum
cleaner to suck
up dirt.
When the pre-filter is very dirty,
wash it with warm water or
clean water and dry it well.

Silver ion filter

Soak the silver ion filter in water.
1
Remove the pre-filter.
2
Remove the silver ion filter.
3
Soak the silver ion filter in
water.
Do not use detergent or hot water. Also,
do not use a brush or similar tool to
scrub the filter or rub the filter while
soaking. This may damage the filter.
z There may be yellow or dark stains
10
remain on the filter, but they will not
affect the performance.
z The filter can be soaked for a total of
eight times. After that, replace it with
a new one.
4
Dry the silver ion filter well.
Do not hang the filter with pegs or the
like. This may damage the filter.
Do not use the filter when it is wet.
5
Set the silver ion filter.
6
Set the pre-filter.
How to remove and attach the filter
Soak in cool or warm
water for about 30
minutes.
Dry the filter on a flat
surface.
10