Aastra 5360 User Manual page 38

Supplementary features
Call recording only starts when the connection is set up. Therefore, no ring-back
tones or wait tones are recorded.
Call recording is temporarily interrupted during an enquiry and an e-mail is sent with
the recording made up till then. Recording restarts automatically once the call con-
nection with the enquiry call party is set up and/or once the call connection with the
first correspondent is restored.
The maximum recording time for each .wave file depends on the system configura-
tion. When the preset or maximum recording time is reached, the recording stops
automatically, the file is sent to your e-mail address and a new recording starts at the
same time. Contact your system administrator for more information.
Notes:
• Recording calls may infringe on your national data protection provisions or be
permitted only under certain circumstances. If you intend to use this function
notify your call party in advance.
• You cannot record a conversation involving more than two call parties (enquiry
call, conference). The recording is automatically stopped if you park your call
party or put him on hold.
You can start or end call recording with the Foxkey or with a configurable key.
Record/Stop
38
Recording a call:
Press Foxmenu > Record
have an incoming/outgoing call or an active call.
➔
Call is recorded.
End the recording with the
➔
The recording is sent to your e-mail address.
Note:
The LED on the function key remains lit while the recording is in progress. The
LED starts to flash before the recording reaches its maximum preset duration.
Once the maximum duration is reached (or the memory is full), the recording is
stopped and the LED goes off.
Call recording overview:
You can find the call recording overview in your e-mail box.
or function key for <Call
Stop Foxkey.
recording> as soon as you
eud-1279/1.1 – R2.0 – 02.2012