Using Authentication Unit (Ic Card Type); Configuring This Machine - Konica Minolta Bizhub C360 User Manual

11.1

Using authentication unit (IC card type)

11 Authentication unit (IC card type)
This chapter describes the Authentication Unit (IC card type) AU-201.
1. Authentication Unit (IC card type) AU-201
11.1 Using authentication unit (IC card type)
The Authentication Unit (IC card type) AU-201 is an "IC card authentication" system that reads the IC card
to perform personal authentication. Using this system, you can perform authentication with an IC card to log
in to this machine or execute a print job when User Authentication is enabled in this machine.
To use the authentication unit, first register the card ID of the user in this machine. The registered user, who
is authenticated with the card ID, can log in to this machine or execute a print job. This section explains how
to configure the required settings in this machine, register users, and log in with authentication.
NOTICE
Authentication Unit (IC card type) AU-201 must be installed inside the Working Table WT-507 or Working
Table WT-506.
Do not disconnect the USB cable while using the authentication unit. Doing so may cause the system to be-
come unstable.
Do not leave the IC card within 1-9/16 inch (40 mm) of the card reader.
11.1.1

Configuring this machine

NOTICE
Authentication Unit (IC card type) AU-201 must be installed inside the Working Table WT-507 or Working
Table WT-506.
User authentication settings must be configured with MFP authentication on this machine.
This device does not support external server authentication. For [Public User Access] or [Account Track] set-
tings, refer to page 7-27. To combine account track settings with user authentication settings, set Synchro-
nize User Authentication & Account Track to [Synchronize].
1
Use the Control Panel of this machine to display the Administrator Settings screen. Press [User Au-
thentication/Account Track], then [General Settings].
bizhub C360/C280/C220 (Version 3)
1
11
11-3