When A Problem Is Detected (Call A Service Representative); Problems That Cannot Be Corrected By The User - Konica Minolta Bizhub C360 User Manual

9.1

When a problem is detected (call a service representative)

9 Troubleshooting
This chapter describes troubleshooting.
9.1 When a problem is detected (call a service representative)
If a problem is detected, perform the operation described in the message. If the problem is not resolved, per-
form the following operations, and then contact your service representative.
Normally, the phone number and fax number of your service representative appear in the center of the
screen.
If a defective part can be separated in order to be able to continue operations after a problem has been de-
tected, [Continue] or [Recover Data] is displayed. To continue operations, select any key. However, the prob-
lem has not been resolved, so contact your service representative immediately.

Problems that cannot be corrected by the user

1
Write down the malfunction code in the Service Call screen.
2
Turn off the Sub Power Switch.
3
Turn off the Main Power Switch.
bizhub C360/C280/C220 (Version 3)
9
9-3