Loading Paper Into The Bypass Tray - Konica Minolta Bizhub C360 User Manual

8
5
Close the LCT tray.
d
Reference
To configure paper settings:
Press [Basic] ö [Paper].

Loading paper into the Bypass Tray

1
Open the Bypass Tray.
% To load large-sized paper, pull out the tray extension.
NOTICE
Be careful not to touch the surface of the Paper Take-Up Roller
with your hand.
2
With the side to be printed on facing down, insert the paper as far as possible into the feed slot.
% The image will be printed on the surface of the paper facing down when the paper is loaded into the
bypass tray.
% Do not load so many sheets of paper that the top of the stack is higher than the mark.
% If paper is curled, flatten it before loading it.
% Push the Lateral Guide firmly up against the edges of the paper.
% Load letterhead paper so that the side to be printed on faces up.
% When loading postcards:
Load them in the w orientation, as shown in the illustration. To
use postcards other than the
4 e 6 (A6) size, check the size of postcards to be used, and
then specify the size on the Custom Size screen before using
them.
% When loading Transparency:
Load them in the v orientation, as shown in the illustration.
8-6
Paper
bizhub C360/C280/C220 (Version 3)
8.1